Aligning Images for Standard Film and Custom Prints

The correct image alignment setup depends on the material you are using. For standard back film, enter the material’s actual size in settings and enable “Center Cutting” on the cutting page. For custom printed designs, set a custom print size for the printer, measure the phone size, and scale and center the image on the material before printing. These settings position the image and cutting area appropriately for each type of material.

Settings for Standard Back Film

When using standard back film, alignment is based on the actual dimensions of the material. The material size entered in settings should match the material being used. A size of 180 × 120 mm is one example, rather than a required size for every material.

1. Set the material size in settings according to the actual material dimensions.
2. Enable “Center Cutting” on the cutting page.

With these settings applied, the cutting area is aligned to the center of the image. The key points are to use the actual material size and to make sure Center Cutting is enabled.

Additional Setup for Custom Printed Designs

Custom printed designs require preparation before printing because the image must be sized and positioned for the phone and the material. The printer must also support the custom print size needed for the design.

1. Set a custom print size in the printer. Consult the printer manufacturer for guidance on this setting.
2. Measure the phone size.
3. Scale the image according to the phone size before printing.
4. Make sure the scaled image is centered on the material before printing.

For this type of design, both scale and placement must be addressed before the image is printed. The image should correspond to the measured phone size while remaining centered on the selected material.

Common Questions

Is 180 × 120 mm required for standard back film?

No specific size is required by the documented setup. The material size should match the actual material being used; 180 × 120 mm is provided only as an example.

Where can I get help with these settings?

If further assistance is needed with standard back film or custom printed design alignment, contact technical support through WhatsApp.