If Cutter App does not launch automatically when the screen protector cutting machine starts, set Cutter App as the device’s Home App. Open System Settings, locate Cutter App under App Management or Default Apps, select it as the Home App, and restart the device. After this setting is applied, Cutter App should start automatically whenever the device boots.
When This Procedure Applies
Use this procedure when the cutting machine starts but Cutter App does not open automatically. This may happen after the device has recently been reset and Cutter App is no longer set as the default home application.
The purpose of the procedure is to restore Cutter App as the Home App so it can launch automatically during device startup. The available menu names or appearance may vary slightly depending on the software version.
Set Cutter App as the Home App
Complete the supported actions in this order:
- Open System Settings. Access the device’s system settings to find the application configuration.
- Locate Cutter App. It is usually listed under App Management or Default Apps.
- Set Cutter App as the Home App. Select Cutter App as the device’s default home application.
- Restart the device. Restarting applies the updated Home App setting.
Confirm Automatic Startup
After the device restarts, check whether Cutter App launches automatically during boot. Automatic launch confirms that Cutter App has been set as the Home App and that the startup setting has been applied.
If the machine had recently been reset, completing this process restores the documented default home application selection needed for Cutter App to open automatically.
Account for Software-Version Differences
The interface may look slightly different across software versions. App Management, Default Apps, Cutter App, and the Home App selection may therefore appear differently on the device, but the supported setting remains the same: locate Cutter App and assign it as the Home App.
Once Cutter App is selected as the Home App and the device has been restarted, the documented completion check is that Cutter App starts automatically when the screen protector cutting machine boots.
Was this article helpful?
Your feedback helps us improve future articles.