Connect a Non-Wi-Fi HP Printer Through PrinterServer

To connect an HP printer without Wi-Fi to the screen protector cutting machine, install PrinterServer on a computer. The computer running PrinterServer, the HP printer, and the cutting machine must all be connected to the same network, described as the same Wi-Fi or LAN environment. After installing the software and arranging the network connection, follow the video tutorial provided for the final connection setup.

When This Connection Method Applies

This procedure applies to a printer brand other than Canon or Epson, including an HP printer without Wi-Fi. These printers use PrinterServer installed on a computer to enable the connection with the screen protector cutting machine.

The documented printer requirements also state that the printer must support photo printing because the film material is thicker than regular A4 paper. Confirm that the HP printer meets this requirement before proceeding with the connection steps.

Connection Procedure

1. Download and install PrinterServer on the computer. Obtain the PrinterServer software from https://www.mietubl.com/app/Printerserver.rar, then install it on the computer that will be used for the printer connection.
2. Place all three devices on the same network. Connect the computer running PrinterServer, the HP printer, and the screen protector cutting machine to the same network. The supported network arrangement is described as the same Wi-Fi or LAN environment.
3. Complete the connection setup. After PrinterServer is installed and all three devices are on the same network, follow the method shown in the video tutorial provided with the connection instructions.

Completion and Documented Limitation

The documented endpoint is completion of the connection setup by following the video tutorial after PrinterServer has been installed and the three devices share the same network. No separate connection test or additional verification procedure is specified in the supplied instructions.

This process does not describe a direct connection between the HP printer and the cutting machine. The supported method requires a computer running PrinterServer as part of the same network environment.

Source Basis

The PrinterServer download used in this procedure is the approved software source: https://www.mietubl.com/app/Printerserver.rar. The connection requirements and sequence are based on the supplied HP printer setup instructions.