If the 180T screen protector cutting machine displays a “Reconnect” or “Reconnection” message after startup, the documented likely cause is an issue with the system firmware. Upgrade the firmware first. The expected result is that the machine starts without displaying the message. If the issue continues after the firmware upgrade, it may indicate a mainboard problem, and the mainboard will need to be replaced.
Documented Symptom and Likely Cause
This troubleshooting guidance applies specifically to the 180T screen protector cutting machine when the Reconnection message appears after startup. The documented likely cause is a system firmware issue. The message alone does not confirm that the mainboard has failed, so the firmware remedy should be completed before concluding that mainboard replacement is necessary.
A separate startup condition may display a “Timeout” error while the Reconnect control is unresponsive. That condition can involve screen firmware loss, a loose or broken connection between the screen and mainboard, or mainboard failure. Because those details apply to the distinct Timeout symptom, they should not be assumed to explain a Reconnection message by itself.
Supported Troubleshooting Actions
- Upgrade the system firmware. This is the documented first remedy for an 180T that displays the Reconnection message after startup.
- Check the result after the upgrade. Determine whether the machine now starts without showing the Reconnection message.
- Replace the mainboard if the message persists. A continuing Reconnection message after the firmware upgrade may indicate a mainboard problem. In that case, the documented remedy is mainboard replacement.
No additional checks or configuration changes are documented for this specific startup message. In particular, procedures associated with different errors should not be substituted unless the machine is displaying those separate symptoms.
Expected Result and Escalation Point
After a successful firmware upgrade, the expected result is that the 180T starts without displaying the Reconnection message. This outcome indicates that the documented firmware remedy resolved the startup issue.
If the same message remains after the upgrade, the firmware action has not resolved the fault. The documented conclusion is that the mainboard may be the source of the problem and will need to be replaced. Mainboard replacement is therefore the escalation point, not the first troubleshooting action.
Was this article helpful?
Your feedback helps us improve future articles.