Stop Film Bulging by Correcting the Blade Setup
Film can bend or bulge during cutting when the blade holder is set too deep, the blade is worn out, or a non-original blade does not match the required angle and sharpness. Reduce the blade...
Search
Find an article
Showing 474 results for "screen-film retail"
Fix Incomplete Full-Wrap Back Film Cuts
When a full-wrap back film does not cut completely, disable the “Center Cut” option on the cutting page. Full-wrap films have larger dimensions, and centering can prevent the machine from us...
Restore Full Lamination Cutting by Disabling Cut Center
If the machine cuts only the camera area instead of the full lamination, disable the Cut Center option on the cutting page and try cutting again. This remedy applies especially when cutting...
Default Cutting Settings and Material-Specific Ranges
The basic default setup is a material size of 180 mm width × 120 mm height, cutting pressure of 300, cutting speed of 200, and blade holder scale of 5. These defaults are suitable for most m...
Film Cutting Machine Use Does Not Include Mobile App Control
No. The film cutting machine does not have an app for iOS or Android. Its operation requires you to place the cutting material on the machine manually. Because that physical step is still ne...
Aligning Images for Standard Film and Custom Prints
The correct image alignment setup depends on the material you are using. For standard back film, enter the material’s actual size in settings and enable “Center Cutting” on the cutting page....
Prevent Incomplete Full Back Film Cuts
Slices may be thrown out or cut incompletely halfway because the configured material size does not match the template. This is especially relevant when cutting full back film, whose cutting...
Unlock Word Cutting with App Version 3.0.03 or Later
Graphic cutting and custom text cutting depend on the installed app version. The documented Word Cutting feature is available only in version 3.0.03 and above. Check your current version in...
Access Name Printing with the Word Cutting Feature
To access the feature used for printing a name on skin, your app must be version 3.0.03 or later. Check the current version through About This Device. If it is earlier than version 3.0.03, o...
Access Word Cutting After Updating the App
To use Word Cutting, confirm that the app is running version 3.0.03 or above. Check the installed version in “About This Device.” If it is lower than 3.0.03, open “My,” select “App Upgrade,”...
Resolve a Film-Cutting “Time Out” by Checking Mainboard Status
When a “Time Out” message appears during film cutting, open My → About this machine and check whether a QR code is displayed. No QR code indicates a mainboard malfunction, and the documented...
M288 Mainboard Replacement for Startup and Cutting Faults
If the MTB-CUT M288 intelligent film cutting and pasting machine displays a “Reconnection” message at startup or its cutting car fails to cut properly, the mainboard may be faulty. For eithe...
Use Speed 200 for Most Cuts and Slow Down for Special Materials
In most cases, keep the cutting speed at the default value of 200. This setting provides good cutting performance for the majority of materials. Reduce the speed only in special situations,...
Replace an M288 Fixture That Cannot Hold a Phone Properly
The MTB-CUT M288 intelligent film cutting and pasting machine uses a modular fixture design. If its fixture is unable to properly hold a phone, replace the fixture by following the method de...